Publicité
After thoroughly cleaning the chuck, before replacing, it should be slightly greased on the outer surface
(e.g., with Vaseline).
Only fasten the chuck lightly when reinstalling! The chuck will fix itself firmly as part of its normal operation.
To optimise the precision and durability of the chuck, a tool or the factory supplied protective pin
must always be fixed, even when not in use.
Never clean the handpiece with compressed air!
7.3 Technical data
diameter max:
length:
weight without cable:
weight with cable:
cooling:
drive system:
Concentricity:
chuck standard:
The oscillation total value during operation is below 2,5 m/s².
8. motor MT W with W 90 and W 50
W 90
art.no.: 10101
contra angle handpiece 90°
W 50
art.no.: 10103
contra angle handpiece 50°
28 mm
142 mm
230 g
360 g
self sealing system without cooling
brushless DC-motor
< 0,03 mm
ø 6,0 mm
9
9
MT W
art.no.: 10105
motor for contra angle handpiece
Publicité
