Preparation - Blomberg BRFD2230SS Manuel D'utilisation

4

Preparation

Before starting to use the product, check that all
preparations are made in accordance with the
instructions in sections "Important instructions for
safety and environment" and "Installation".
Clean the interior of the refrigerator as
recommended in the "Maintenance and
cleaning (Page 31)" section. Check that inside
of it is dry before operating it.
Plug the refrigerator into the grounded wall
outlet. When the door is opened the interior
illumination will turn on.
Run the refrigerator without putting any food
for 6 hours and do not open its door unless
absolutely required.
Do not allow the food to touch the temperature
sensor in fresh food compartment.
C
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running and this is quite normal.
C
Front edges of the refrigerator may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
C
The ambient temperature of the room
where you install the refrigerator should
10ºC /50°F
at least be
refrigerator under cooler conditions than
this is not recommended.
C
Inside of your refrigerator must be cleaned
thoroughly.
. Operating your
14 /37 EN
To allow the fresh food compartment keep its
ideal storage temperature, sensor must not be
hindered by food.
Refrigerator / User Manual