Publicité
HOW TO USE THE BLANK STRAINER / CITRUS MAKER
BLANK STRAINER
CAUTION
• The recommended amount for a single use is less than 300g.
• For efficient ice cream preparation, use frozen ingredients
immediately after removing them from the freezer.
• Insert the prepared ingredients into the auto-feeding inlet
in small amounts, less than 3 cm, and slowly add them as
they go down.
01
Place the ice cream strainer's ring into the
groove of the ice cream strainer as shown in
the picture.
02
After placing the ice cream strainer onto the
screw, assemble it by aligning the marking
point on the drum container with the marking
point on the ice cream strainer.
03
Turn the auto hopper clockwise until the
markings on the auto hopper align with the
lock markings on the drum container.
04
Place the juice cup under the outlet. (Ice
cream is discharged through the pulp
outlet.)
* The ice cream strainer's ring is detachable and
washable.
* If the ice cream strainer's ring is not properly
fastened, the ice cream strainer cannot be
assembled to the drum.
* If any frozen ingredients remain inside the
screw or hopper, use the pusher to push it into
the screw.
10
CITRUS MAKER
*OPTIONAL
CAUTION
• If not cleaned immediately after use, residue can dry and
adhere, making decomposition and cleaning difficult,
as well as potentially leading to performance degradation.
01
Place the strainer onto the citrus maker
drum.
02
Insert the cone into the center of the
strainer to assemble.
03
Position the assembled citrus maker onto
the base clamp and press the power button
to start operation.
04
Cut the fruits in half and press them gently
on the cone.
If the strainer accumulates an excessive amount
of pulp, wash it and then resume juicing.
* The amount of juice may vary depending on the
characteristics of the ingredients.
Cover
Cone
Strainer
Drum
Base
TROUBLESHOOTING Q
A
&
When there is no power
• Check if the power cord is properly plugged in.
• Check if the drum lid and the juicing bowl are properly
assembled.
• Check if the top-set and the body are properly assembled.
*
Juicer will not operate if parts are not properly assembled and if
the arrows are not aligned.
Low juice yield
• The amount of juice extracted may vary depending on the
water content of the ingredients.
• If the ingredients are not fresh, they may have lower water
content and produce less juice.
• Ingredients with small, soft seeds may leave residual seeds
at the bottom of the juicing mesh, which can hinder juicing
efficiency and affect the overall juice yield. To ensure smooth
juicing, it is recommended to disassemble the drum set and
clean it during the juicing process.
*
If there is seed residue on the bottom of the strainer, this can
affect juicer's performance and the overall juice yield.
The auto hopper will not close
• Make sure the juicing screw is pushed all the way into the
strainer in order for the drum lid to close properly.
*
If the juicing screw is not properly in position, the auto hopper
may not close.
Noise from the juicer
• Check if the parts are assembled correctly.
Try to reassemble the parts and check for noise.
• If the juicer is operated without any ingredients or liquid, the
noise can be loud, and it can cause the damage
• The friction noise from the juicing screw and the strainer will
disappear when ingredients are inserted into the juicer.
• If the noise occurs when ingredients are inserted into the
juicer, check the size of the ingredients. Do not insert any hard
ingredients that are more than 1 inch thick.
*
The noise can occur if the juicer is operated on an uneven or
slanted surface. Place the juicer on a horizontally flat surface
when operating.
During operation, the drum shakes
• The juicing screw and the strainer are set up to crush and
squeeze the ingredients. It is normal for the juicing screw and
the strainer to vibrate.
• If the ingredient contains strong fiber, the vibration from the
top-set may be stronger.
During juicing, the motor stopped
• Check the power cord and make sure it is plugged in correctly.
• Check that all the parts are correctly assembled.
• If too many ingredients are inserted at one time, this can cause
the juicer to stop.
• When the juicer stops because there are too many ingredients
inserted in it, press the REVERSE - OFF - FORWARD button in
this order, switching back and forth 2 to 3 times.
• The reverse setting will push the ingredients up, and the
forward setting will pull the ingredients down.
• After using the juicer continuously for more than 30 minutes,
the overload protection feature may stop the juicer. Let the
juicer cool for 30 minutes to 1 hour before juicing again.
• If there are hard seeds within the ingredients, remove them
before juicing. Hard seeds can damage the juicer.
Layer separation of juice
• Depending on the density of the ingredients, the extracted juice
may show layers of different juices. It is different from separation
due to oxidation caused by juicing with a high-speed juicer.
Juice dripping down the body
• If the silicone parts on the bottom of the pulp outlet are not
plugged in correctly, the juice may seep out on to the juicer
body. Before assembling the parts, make sure the silicone parts
are plugged in correctly.
Is it possible to juice ingredients with tough fiber?
• Ingredients like celery or ginger contain long fibers that
may wrap around the juicing screw and affect the juicer's
performance. When juicing fibrous ingredients, cut them into
smaller pieces and alternate with other ingredients. Clean the
top set regularly if juicing larger amounts of fibrous produce.
Plastic parts are discolored
• After juicing, if the juicer is not cleaned right away, the
remaining pulp inside the top-set can dry up which can make
disassembling and cleaning hard. This can also affect the
juicer's performance and color.
• Ingredients that are rich in carotenoids such as carrots and
spinach may dye plastic parts.When the parts are dyed with
carotenoids, rub vegetable oil or lemon juice into the dyed
areas and use mild detergent to clean.
• Vegetable oil should only be used during clean-up for parts
that are discolored. Do not use vegetable oil on the juicing
screw or the strainer. If vegetable oil or oil from animal fat gets
on the juicing screw or the strainer, this can affect the juicer's
performance and may result in damaged parts.
• The silicone pieces on the top-set can be detached to be
thoroughly cleaned.
Using for different purposes
• This juicer is designed for home use suitable for juicing like
fruits, vegetables, soaked nuts, and soaked soybeans.
• Do not use the juicer for extracting oils or butters.
• Do not juice ingredients with high contents of vegetable/
animal oil.
• If vegetable/animal oil gets on the juicing screw or the strainer,
this can affect the performance of the juicer and could result in
damaged parts.
*
The lifetime of each part may vary depending on length and
method of use and ingredients extracted.
EN
11
Publicité
