Publicité
HOW TO ASSEMBLE
DRUM SET
STEP 1
STEP 2
Juicing drum
&
Juicing Screw
Drum Set
&
Juicing Strainer
01
03
Insert the juicing strainer
Place the auto hopper
onto the juicing screw.
onto the drum container
aligning
Make sure that the silicone
the auto hopper with
parts of juicing drum are
the unlock mark
properly inserted before
the juicing drum.
assembling.
02
04
Assemble it so the
Turn the auto hopper
red dot on the juicing
clockwise until the
strainer matches the red
sign on the auto hopper
dot on the juicing drum.
is lined up with the lock
mark
drum.
6
TOP SET
BASE
STEP 3
&
Auto Hopper
&
05
Place the assembled top
set on the base clamp in
the sign on
an aligned way.
on
06
Place the juice cup1
and juice cup 2 under
the juice spout and pulp
spout.
on the juicing
HOW TO OPERATE
CAUTION
TOP SET
Clamp
FWD
REV
• Operating the juicer without ingredients can cause damage to the juicing screw.
• Do not continuously operate the juicer for more than 20 minutes. This can damage the motor from overheating.
After continuous use, let the juicer rest for 30 minutes to cool down before starting another session.
01
Open the automatic hopper lid by lifting the locking tab up and
ingredients.
Do not feed ingredients over the maximum capacity line.
* Please refer to page 8 for preparation of ingredients.
02
Press the locking tab and completely close the auto hopper lid,
and then put the juice cups in place aligned with the juice and
pulp outlets.
If the auto hopper lid is not completely closed, the device will not work.
* Keep the smart cap open. If you close the smart cap and juice, the juice
may flow back into the hopper, and juice leaks may form at the connection
between the hopper and the drum set.
03
Press the [FWD] switch to start operation.
If the product stops during use, set the switch to [STOP (O)], stop the
operation completely, and return the ingredients upwards with the
[REVERSE(REV)] switch.
* The [REVERSE(REV)] switch works only while it is pressed, Hold the REVERSE
button for 2-3 seconds and release.
04
Add ingredients through the auto hopper hole while the juicer is
running.
If the Auto Hopper Lid is opened and ingredients are feeding in,
the operation will stop.
05
Turn off the power switch once juicing is complete and all pulp
and fiber are discharged.
Run the juicer until the pulp is completely discharged.
EN
7
Publicité
