Publicité
STEP 1
Fill liquid inlet and outlet of pump with one (1) table spoon of vegetable oil.
STEP 2
Install suction and discharge line to their respective connectors.
STEP 3
Plug cord into a 3 prong 115 VAC receptacle.
Unplug pump when liquid supply is exhausted. The overheat due to dry
STEP 4
running will damage impeller or weld it to the pump body.
The shaft motor seal is generally good for the lift of the pump. When shaft seal leaks, it
is because enough abrasives have been pumped to wear deep grooves in the shaft
under the seal. In this situation, the purchase of a whole unit will cost less than
repairs (motor and pump).
Brush replacement is done quickly and easily. Unscrew
brush cover, then remove spring and worn brush. Insert
the replacement brush and spring kit in the same
position and replace brush cover. Never drop oil in brush
area. This may damage the motor and void warranty.
Impeller replacement is also easy to do. Remove pump
cover screws and cover. Remove worn impeller. Clean
out inside of pump body and examine the volute plate. If
worn, turn over. Wipe a small quantity of oil and install the
replacement impeller by twisting in clockwise direction.
This will blend the blades in place. Using screws, replace
pump cover. Do not overtight.
4
FOR INFORMATION | TEL : 514.337.4415 | FAX : 514.337.4029
INSTALLATION STEPS
MAINTENANCE
3
Publicité
