Publicité
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
THE FRONT AND BACK
1. Loudspeaker selectors 1 through 4
Press the button to listen to the desired loudspeakers.
2. Connection from amplifier
From the L(eft) and R(ight) loudspeaker output of your receiver or amplifier (100 watt max).
3. Loudspeaker Connections
Connections to be made from 4 speaker selector to the desired loudspeakers, with the corresponding selector on the front
panel.
CONNECTIONS
Installation tips:
1. 0.75mm2 to 1.5mm2 is recommended loudspeaker wire is recommended, 2.5mm2 is recommended for runs longer than 15
meters.
2. Any combination of 4-, 6-, 8- and 16-ohm loudspeakers can be connected to the switch box.
3. Try to avoid running power cables along speaker cables as this can cause interference.
3
Publicité
