Publicité
This fine pump that you have just purchased is designed from the latest in
material and workmanship.
Before installation and operation, we recommend the following procedures:
Check with your local electrical and plumbing codes to
A
ensure you comply with the regulations. These codes
have been designed with your safety in mind. Be sure you
comply with them.
We recommend that a separate circuit be lead from the
B
home electrical distribution panel properly protected with
a fuse or a circuit breaker. We also recommend that a
ground fault circuit be used. Consult a licensed electrician
for all wiring.
The ground terminal on the three prong plugs should
C
never be removed. They are supplied and designed
for your protection.
Never make adjustments to any electrical appliance or
D
product with the power connected. Do not only unscrew
the fuse or trip the breaker, remove the power plug
from the receptacle.
Material required for laundry tub application :
Desired length of ABS/DWV 1 1/4'' and 1 1/2'' pipe, to link up from pump discharge
to waste or drain existing pipe.
Required quantities of 1 1/4'' and 1 1/2'' ABS/DWV elbow(s) and/or other fitting(s)
to run the discharge line.
Teflon tape and ABS cement.
A check valve is supplied to prevent the backflow
of water when the pump shuts off.
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench, allen wrench.
SAFETY INSTRUCTIONS :
This unit is not designed for
applications involving salt water
or brine. Use with salt water or
brine will void warranty.
2
(indoor use only)
NOTICE
Publicité
