Publicité
Operating Your Whirlpool
- Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
NOTE: The water temperature in the whirlpool should never exceed 104_F (40_C). A built-in heater automatically
maintains the water temperature when the whirlpool is running, as long as the water temperature does not
exceed 104_F (40_C). The heater will disengage at higher temperatures.
- Close the drain, and fill the whirlpool to a level at least 2" (5cm) above the top of the highest jet. Use your hand to
test the water temperature for comfort and safety, then carefully enter the bath.
- Press Power to turn on the whirlpool. The heater will also turn on and the whirlpool will start at medium volume.
- Increase or decrease the water flow by pressing the up or down arrows on the keypad. An indicator bar in the
center of the keypad shows the water flow volume.
- Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow, and
counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired to maximize your
hydro-massage experience.
- The heater automatically engages when the whirlpool is turned on. To turn the heater off, rotate the outer ring
until the heater mode is flashing and press "OK". Press "OK" again to turn the heater back on.
- Press Power a second time to turn off the whirlpool.
NOTE: Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can
restart the whirlpool, if you desire, by pressing Power.
Neckjet Operation
- Make sure the slip cover is in place on the pillow, and the pillow is attached to the neckjet body.
- With the whirlpool operating, rotate the outer ring until the neckjet mode is flashing. Press "OK" to activate the
neckjets. The neckjet pulsing action will start at medium speed.
- To increase or decrease the neckjet pulsing action, press either the up or down arrows on the keypad.
- To increase or decrease the neckjet flow volume, rotate the outer ring until the Flexjet flow mode is flashing, press
"OK" and press either the up or down arrows on the keypad.
- To activate or deactivate functions while the neckjets are operating, rotate the outer ring until the desired function
is flashing and press "OK". (Example: To turn the heater off, rotate the outer ring until the heater mode is flashing
and press "OK".
- Press "OK", while the neckjet mode is active, to turn off the neckjets.
- Press Power to turn off the whirlpool.
NOTE: Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can
restart the whirlpool, if you desire, by pressing Power.
- Carefully exit the bath and open the drain to empty the whirlpool.
NOTE: If the whirlpool does not function properly, please refer to Troubleshooting on Page 11.
B
1019488-5-
All manuals and user guides at all-guides.com
Fill with water 2" (5cm)
above the highest jet
Turn the jet trim
clockwise to
decrease the flow
Position the jet
nozzles to direct
the water flow as
desired
Turn the jet trim
counterclockwise to
increase the flow
6
Kohler Co.
Publicité
