Publicité
Problem
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the problem persists, contact the
Authorised Service Centre.
7.2 Replacing the lamp
Use LED bulbs (E14 base) designed for
household appliances. Check the
maximum power on the lamp unit.
CAUTION!
Disconnect the plug from the mains
socket.
1. Pull the left side of the lamp cover to
unlock it. Remove the cover by pulling it
towards yourself.
22
ENGLISH
Possible cause
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food is too hot.
Too much food is stored at the
same time.
The door has been opened often.
There is no cold air circulation in the
appliance.
1
2
1
Solution
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Refer to the "Closing the door" sec‐
tion.
Let the food cool down before stor‐
age.
Store less food at the same time.
Open the door only if necessary.
Ensure cold air circulation in the ap‐
pliance. Refer to the "Hints and tips"
chapter.
2. Replace the bulb with one of the same
power and shape.
3. Install the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door and make sure that the
light switches on.
7.3 Closing the door
1. Clean the door gaskets.
2. To adjust the door, refer to installation
instructions.
3. To replace the defective door gaskets,
contact the Authorized Service Centre.
Publicité
