Publicité
3.5
Install the lens. Adjust the back focus ring to match lens type used, clockwise
for C mount or counter-clockwise for CS mount.
3.6
If an auto-iris lens is used, connect the cable of the lens to the mini-din connec-
tor supplied with the camera.
3.7
Insert the lens connector into the auto-iris connector on the camera.
3.8
Route a video cable from the monitor device to the camera.
3.9
Plug the cable into the BNC output connector labeled "video out" on the rear of
the camera.
3.10
Plug the other end of the cable into the video input port on the rear of the
monitoring device.
On 230 VAC models:
3.11
Plug the power cord into a wall outlet.
3.12
Apply 230 VAC power to the camera.
On 12VDC and 24VAC models:
3.11
Connect a two conductor power cable to the AC 24V or DC 12V input on the
rear of the camera. See figure 1.
3.12
Apply AC 24V or DC 12V power to the camera.
3.13
Adjust the camera back focus, lens focus and iris controls for an optimum
picture.
NOTE:
Do not aim or point the camera toward the sun or into a strong light.
12V DC / 24V AC
CLASS2
+
~
G
FIGURE 1.
All manuals and user guides at all-guides.com
Use
AC or 12V DC power adapter. When using 12V
DC power adapter, connect
and ,
Power Source.
~
UL Listed Class 2 Power Transformer,
pole to
position. Only use a Class 2
8
24V
+
+
pole to
position
Publicité
