Program Change Enable/Disable - Korg K-Serie Manuel D'utilisation

The local control setting
Local control on
Local control off
The local on/off setting is set to local on if power cut off.

Program change enable/disable

Every time you select one of the K61P's internal sounds, a MIDI program change
message is also sent to any connected MIDI equipment. This feature allows you to
prevent program change messages from being sent to your other MIDI devices.
1
Hold down [BANK] button until the K-Series enters the Setting mode.
2
Press the Program 7 [HARPSI 1/VIBE/STRINGS 1] button (the button will flash).
3
Press note C4(enable) or C#4(disable) to select the setting.
4
Press the [BANK] button to exit the Setting mode.
20
Computer
KBD/KNOB
SOUND/CTRL
Computer
KBD/KNOB
SOUND/CTRL
C1 C2 C3
K61P
Keyboard/Each controllers
Tone generator
K61P
Keyboard/Each controllers
Tone generator
C4 C5 C6 C7 C8