Publicité
Truing cutter blades
•
Before mounting the cutter blade on the cutter shaft the blade must be trued with the blade setting
gauge.
•
Fort his place the cutter blade and angle setting piece flush on the blade setting gauge, and screw both
parts tightly together.
Mounting cutter blades on cutter shaft
•
Insert the cutter blades into the groove on the cutter shaft with the angled portion of the setting piece.
Mount the cutter pressure plate and screw up tightly with the three screws. Before mounting the cutter
shaft clean it thoroughly with a brush.
•
Important: To avoid imbalance always fit similar blades.
•
Change blades in pairs only.
•
When correctly set, the blades run absolutely paralel to the rear sole-plate of the plane.
Changing drive belt
Undo the two screws on the drive shaft cover and remove the cover. Remove the defective drive belt, if
necessary, by cutting it with a knife. Clean the belt pulley wheels with a brush. Insert a new drive belt into
the grooves on the smaller pulley wheel and then turn it on to the larger pulley wheel. Replace the cover.
Changing carbon brushes
Check the carbon brushes regularly. As soon as they have worn down to a length of less than 6mm, the
carbon brushes must be replaced. Always replace carbon brushes in pairs.
For safe and proper working, always keep the machine and the ventilation slots clean.
If the machine should happen to fail despite the care taken in manufacture and testing, repair should be
carried out by an authorized customer services agent for RTRMAX power tools.
EN
5
Publicité
