Publicité
•
Use safety equipment. Always wear eye protection. Safety equipment such as dust mask, non-skid safety
shoes, hard hat, or hearing protection used for appropriate.
•
When working with the machine, hold it firmly with both hands and provide for a secure stance.
•
Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of
electric shock.
•
When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
•
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust. Power tools create sparks which may ignite the dust or fumes.
•
When power tool is given to other people, this instruction manual must be given with power tool.
•
Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
WARNING: Stay alert, watch what you are doing and use common sense when operating
a power tool. Do not use a power tool while you are tired or under the influence of drugs,
alcohol or medication. A moment of inattention while operating power tools may result in
serious personal injury.
•
Keep the tools out of reach of children.
•
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
•
Disconnect the plug from the power source before making any adjustments, changing accessories,
or storing power tools. Such preventative safety measures reduce the risk of starting the power tools
accidentally.
•
Never use the cord for carrying, pulling or unplugging the power tool.
•
Don 4 switch off the tool when it is on load.
•
Keep work area clean and well lit. Cluttered and dark areas invite accidents.
•
Avoid the anormal body moving, when operating the tools.
•
Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carry power tools
with your finger on the switch or plugging in power tools that have the switch on invites accidents.
•
Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to
a rotating part of the power tool may result in personal injury.
•
Use only properly sharpened cutter blades for good cutting performance and tool care.
•
Do not run the plane over metal objects, nails and screws. Use only cutter blades that have been
properly checked and are approved for use at the speed specified on the plane. To ensure totally safe
operation read the safety hints first and carefully follow instructions given in them. Before use check the
plane, plug and power lead. Damage must be repaired by a specialist only.
•
Before inserting the plug switch the plane off.
•
Always position the lead so that it runs back away from the tool.
•
Always start the plane up before applying it to the workpiece.
•
While planing, the plane must always lie flat at all points.
•
Always use both hands to guide the plane.
•
Move the plane evenly forward over the workpiece to increase the useful life of the plane cutters and
reduce hazards.
•
Never put your fingers in the chip discharge hole. If the discharge hole is blocked, pull out the plug and
remove the chips from the discharge hole with a wooden stick.
•
On completing work do not put the plane down until the cutter shaft has stopped rotating.
•
Do not use the machine by fitting a place.
•
Before using the plan efor the first time check the setting and seating of the cutter blade and cutter shaft.
Operating
Pay attention to voltage of electric. Always use the correct supply voltage: The power supply voltage
must match the information quoted on the tool identification plate.
EN
3
Publicité
