Publicité
Depth of cut may be adjusted by simply turning the knob on the front of the tool so that the pointer points
the desired depth of cut.
Tecnical data
•
VOLTAGE
•
INPUT POWER
NO LOAD SPEED
•
•
CUTTING DEPTH
•
WIDTH
Power tool's units
1. ON/OFF SWITCH
2. LOCKING BUTTON FOR ON/OFF BUTTON
3. SOLE PLATE
4. SETTING KNOB
NOTE
Using area
For hand-operated planing, cutting of chamfers and rebating of wood and wood-based materials.
Safety instructions
Read all instructions failure to follow all instructions listed below may result in electric shock, fire and/or
serious injury.
•
The voltage of the power source must agree with the value given on the nameplate of the machine.
•
Before using the tool, check the tool and it5s power connections if there is any damagement.
•
Don't connect the plug to power source when switch is on.
•
Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your body is earthed or grounded.
•
Extreme temperature differences cause water droplets on power conducting parts. Before switch on the
tool, wait tool to get same temperature working room temperature.
•
Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the
manner intended fort he particular type of power tool, taking into acccount the work conditions and
the work to be performed. Use of the power tool for operations different from intended could result in a
hazardous situation.
•
Fit workpieces and for fitting the workpieces, use clamping equipments or vice.
•
Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from
moving parts. Loosing clothes, jewellery or long hair can be caught in moving parts.
EN
2
220-240V ~ 50/60Hz
800W
17000 RPM
0-2,5 mm
82 mm
Publicité
