Publicité
6. Labels on tool
The label on your tool may include the following symbols:
Hz ....... Hertz
Read
Instructions
W ........ Watts
Manual
min ..... minutes
Use Eye
Protection
..... Alternating
Use Ear
Protection
..... Direct
V ........ Volts
n
....... No-Load
0
A ........ Amperes
Position of date barcode
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing
7. Electrical safety
Your tool is double insulated; therefore no earth
wire is required. Always check that the main
voltage corresponds to the voltage on the rating
plate.
Warning! If the power cord is damaged, it must
be replaced by the manufacturer, authorized
STANLEY Service Center or an equally qualified
person in order to avoid damage or injury. If the power cord
is replaced by an equally qualified person, but not authorized
by STANLEY, the warranty will not be valid.
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting A Router Bit (Fig. B)
•
Remove the chip deflector (8).
•
Keep the spindle lock button (5) depressed and rotate
the spindle until the spindle lock fully engages.
•
Loosen the collet nut (12) using the spanner provided.
•
Insert the shank of the router bit (13) into the collet (6).
Make sure that the shank protrudes at least 3mm from
the collet as shown.
...... Class II
Construction
....
Earthing
Terminal
....
Safety Alert
Current
Symbol
.../min..
Revolutions
Current
or Recipro-
cation per
minute
Speed
(Original instructions)
•
Keep the spindle lock button (5) depressed and tighten
the collet nut (12) using the spanner provided.
Fitting The Edge Guide (Fig. C)
The edge guide helps to guide the tool parallel to an edge.
•
Fit the bars (14) to the edge guide (15) using the two
screws (16) provided.
•
Insert the bars (14) into the router base as shown.
•
Set the edge guide to the required distance.
•
Tighten the fixing screws (17).
Fitting The Dust Extraction Adaptor (Fig. D)
The dust extraction adaptor allows you to connect a vacuum
cleaner to the tool.
•
Connect the hose (18) of the vacuum cleaner to the
adaptor (11).
Fitting The Template Guide (Fig. E)
(Template Guide Not Included)
•
Fit the template guide (19) to the base of the router, with
the flange to the bottom (workpiece) side.
•
Insert the two long screws (20) from the bottom side
through the template guide and the holes in the base.
•
Place a nut onto each of the screws and securely tighten
the nuts.
Fitting The Distance Piece (Fig. F)
(Distance Piece Not Included)
•
Fit the distance piece (21) to the base of the router using
the screws provided.
Fitting The Centring Pin (Fig. G)
(Centring Pin Not Included)
•
Fit the edge guide to the router as shown in FIG. C, but
upside down.
•
Fit the centring pin (22) to the workpiece side of the
edge guide with the screw (23) provided.
Fitting The Copy Follower (Fig. H)
(Copy Follower Not Included)
•
Fit the edge guide to the router as shown in FIG. C.
•
Fit the 'L' bar (24) to the upper side of the edge guide
using the two screws and nuts provided.
•
Adjust the rotating attachment (25) on the 'L' bar with the
wing knob (26).
ENGLISH
7
Publicité
