Publicité
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reaso-
nable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Requirements for compliance with UL 294
This section contains information and instructions required for UL compliance. To make sure the installation
is UL compliant, follow the instructions below in addition to the general information and instructions provided
throughout this document. In cases where pieces of information contradict each other, the requirements for
UL compliance always replace general information and instructions.
Performance levels for access control:
This section contains performance level information required for UL 294 compliance.
Destructive attack test
Security
Endurance
Standby power
Safety instructions:
• Shall be installed in accordance with Article 725.121 of the National Electrical Code, ANSI/NFPA 70.
• The 2N product shall be installed and serviced by a factory trained professional.
• All interconnecting devices shall be UL listed and Class 2 low-voltage power limited.
• All power outputs are Class 2 outputs.
• All wiring methods shall be performed in accordance with ANSI/NFPA70, local codes and authorities
having jurisdiction.
• The wiring of the door relay is limited only inside of the protected area.
• When the 2N product has reached the end of its useful life, dispose of it according to local laws and
regulations. The product should not be disposed of together with household or commercial waste.
Instructions générales et mises en garde
Feature
88
Level
I
I
IV
I
Publicité
