Publicité
Fitting the seat unit
7. Lower the walker all the way down,
place the walker on a flat level surface
then place the seat unit in to the centre
of the baby walker.
8. Attach all plastic connectors on
the seat unit to the walker body in the
B2
B3
following order:
B1
B4
A. Starting with the seat unit's arm rest
insert pins into keyhole slots (A1) and (A2),
by pushing the pin into the larger end of
the keyhole, then slide the shaft of the
C1
C2
C3
A1
A2
pin into the smaller end of keyhole until it
clicks in place (see Fig 1).
B. Then attach the seat units back rest by
pushing the plastic clips (B1), (B2), (B3)
and (B4) into the holes. Start from one
side and work your way around. Grip the
back of the seat unit as low down and
close to the plastic clip as possible (see
Fig 2) and ensuring the clip is lined up with
it's hole, push the clip in.
Fig 2
If a clip is not protruding from the seat
unit you may need to locate it and pull it
through the hole in the seat cover.
C. Finally insert the pins at the front of the
Fig 1
seat unit into keyhole slots (C1), (C2) and
(C3). (see Fig 3)
Warning: ensure all pins and clips are
properly attached before placing your
child in the seat.
Fig 3
page 7
Publicité
