Publicité
Attaching the walker's front wheels
Attaching the walker's rear wheels
Attaching the walker's anti-fall blocks
A
4. With the baby walker upside down
and fully folded down, insert the two front
wheels into each round hole on either
corner at the front of the walker.
Tip: Use the provided wheel pusher tool
to press the wheels in (tap the back of
the wheel pusher lightly with a hammer if
required)
5. Insert the two rear wheels into each
round hole on either corner at the rear
of the walker, ensuring the small plastic
block (A) is seated in its hole.
Tip: Use the provided wheel pusher tool
to press the wheels in (tap the back of
the wheel pusher lightly with a hammer if
required)
6. With the baby walker still upside down
and fully folded down, place the anti-
fall blocks around the walker as shown,
inserting the two plastic stems on each
block into the holes on the walker's
underside.
ATTENTION! Ensure the narrow end of
each block points to the corner of the
walker.
DO NOT USE THE WALKER WITHOUT THE
ANTI-FALL BLOCKS ATTACHED
page 6
Publicité
