Publicité
Channel Features
Mixer Controls
The EXM Pro10 features a compact mixer control
section, which allows users to independently control
input type, equalization and effects for each chan-
nel� These controls are accessed by the Channel
Select buttons� Simply tap the Channel Select but-
ton for the desired channel, and all settings for this
channel will be displayed and can be configured.
1. Channel Inputs
All three mixer channels are equipped with combi-
jack inputs, which can be used for balanced/unbalanced microphones, line level audio devices, or instru-
ment sources� Additionally, channel 3 features an 1/8" stereo input jack and a Bluetooth® connection
(for wireless audio streaming); both inputs sum the signal to mono and mix it into channel 3�
2. Input Types
Using the Input Type control on the mixer adjusts the
input gain to best suit the connected input type (Line,
Mic, Inst)� The Level control adjusts the gain and relative
volume� The Act/Clip LED ring will illuminate green when a
meaningful signal is being detected at the input and will
illuminate red if the signal is clipping� For powering con-
denser microphones, 48V of phantom power is present on
the XLR portion of the combi-jacks�
Note: The Act/Clip LED responds only to the
strength of the input signal and is not affected by the
channel's level control.
3. Equalization
The EXM Pro10 has a 3-band parametric EQ for each chan-
nel� To set the EQ, push the EQ knob to switch between
Low, Mid and High� You can then turn the knob to set the
desired level� The EQ level is represented through an illu-
minating LED ring� The default position for the EQ knob is
at 12 o'clock, where no EQ adjustments are being applied�
Each EQ band is centered at 60Hz, 850Hz, and 10kHz�
4. Effects
Each mixer channel comes with its own set of controls for
Reverb, Delay and Compression� To set the effect, push
the Effects knob to switch between the three available op-
tions, then turn the knob to set the desired level� The ef-
fect level is represented through an illuminated LED ring�
The default position for Effects is fully counter-clockwise,
where the effect is bypassed�
• A medium-sized Room reverb� The control knob var-
ies the wet/dry mix of the reverb signal�
• A fixed, 90ms Slap-back delay. The control knob var-
ies the wet/dry mix of the delay signal�
• The compressor is configured with a fixed attack,
release and threshold that should suit most applica-
tions� The control knob varies the compression ratio
from 1:1 to 3:1, and will automatically add an ap-
propriate amount of make-up gain based on the control setting�
Note: The Input Type, EQ and Effects controls for channel 3 do not affect Bluetooth® signals
present on the channel.
EXM
CHANNEL
INPUT
EQ
SELECT
TYPE
1
2
3
Push Knob to Select
INPUT
INPUT
TYPE
TYPE
EQ
EQ
EFFECTS
EFFECTS
EFFECTS
INPUT
TYPE
EQ
EFFECTS
2
Publicité
