Publicité
operation
To prevent the spread of infections, single person use is recommended. Before using the
nebuliser for the first time and after each use, clean it and disinfect every part following
the guides in this manual. Dry it well before storing it.
CONNECT THE POWER SUPPLY
The aerosol is equipped with a built-in lithium battery. Charge it fully before using it
for the first time. This appliance can also be used connected to a power supply (not
included). The indicator light is: red when the charge level is low and while charging, blue
when the device is in use, red and blue when it is charging and in use at the same time,
turns off when the device is turned off. After charging, unplug the cable. To charge the
device, use only the supplied USB cable.
NOTE:
Only use chargers with the following electrical parameters:
1. Input voltage: AC 100~240V,50/60 Hz.
2. Output voltage: DC 3~5V,1~2A.
HOW TO ADD MEDICINE LIQUID
Method A: Add medicine to the container (the medicine cannot be more than 10ml)
1. Open the lid of the container upwards and pour the medicine in.
2. Close the lid and fasten the medicine container buckle.
NOTE:
1. Before adding medicine to the container, please remove the main unit from the
adult mask and operate it.
2. After adding the medicine, please check whether there are bubbles. The
bubbles will cause the device to malfunction and stop atomizing. If there are
bubbles, shake the device to remove the bubbles.
3. If there is an obvious liquid leak, check whether the container lid buckle is
fastened and whether the sealing ring inside the medicine container lid is loose
or missing.
26
Publicité
