Publicité
1. Selecting DMX Mode: DMX mode is indicated by an»A» followed
by three digits in the LED. «A» stands for DMX Address and means the
DMX Mode has been activated at present. If «P» appears in the LED
display, means you are in the Chase Mode.
2. Selecting the Channel Mode: Channel Mode is indicated by «CH»
followed by two digits 01,02, 05, 10, 15. You can not use the «EN-
TER» button to select the Channel Mode unless you have called up
the DMX Operation Mode as in step 1.
3. Setting the Channel Value: Once you have activated the Channel
Mode as in step 1, you can tap the «UP» and «DOWN» arrow buttons
to change the setting from 01,02,05 or 10, 15 which you wish to run.
NOTE:
When CH:01is displayed, overall lamps will be controlled by one DMX channel.
When CH:02 is displayed, lamps 1~5 will be controlled by one DMX channel and lamps 6~10
will be controlled by another.
When CH:05 is displayed, channel 1 and 2 will be controlled by one DMX channel, channel3
and 4 will be controlled by one DMX channel, and so forth, channel 9 and 10 will be controlled
by another .
When CH:10 is displayed, each lamp will be controlled by one DMX channel. This is the factory
default setting.
When CH:15 is displayed, each lamp will be controlled by one DMX channel. Other channels
control Chase, speed and Dimming in HTP Mode.
4. Electing DMX Address Mode: DMX Address Mode is indicated
by «A» followed by three digits 001 ~ 512. You can not use the
«MENU» button to select the DMX Address Mode unless you have
activated the DMX Mode as step 1. This mode is the factory default
setting.
5. Setting the DMX Address: Once you have activated the DMX
Mode as step 1, you can use the «UP» and «DOWN» arrow buttons
to select your desired DMX address from 001~512.
User Manual - FUNSTRIP 2R
V1.3 11/2021
A:001
CH:001
CH:001
A:001
A:001
8/22
Publicité
