Publicité
6. Enter button
7. DMX Out
8. DMX In
9. Power Input
10. Power Output
11. Fuse
12. Power Switch
6. Operation Guide
Operation Modes:
The «Funstrip DMX» has two different operation modes. It can be used a 10 channel
chaser or as a 01, 02, 05, 10, 15 channel DMX dimmer. Please follow illustrations below
to operate the unit in your desired mode.
DMX Mode:
Use this operation mode only when you are about to use the unit as a DMX dimmer.
This function can allow you set your unit dimmer function as a 01, 02, 05, 10, 15 channel
DMX dimmer and DMX address.
User Manual - FUNSTRIP 2R
This button will active the different functions in DMX and Chase mode.
Note: In the Chase mode, Menu key is used to only activate Chase
Dimmer (d), Chase Program (P), Chase Speed (SP).
In the DMX mode, only used to select DMX Address (A), Channel (CH).
To connect your DMX signal through to the next unit.
To connect your your DMX input signal.
AC 230V-50Hz, Max 16A
AC 230V-50Hz, Max 16A
F6.3A250V 5*20mm. This fuse prevent you from overloading dama-
ging your unit. Be sure to always replace with the exact same type
fuse.
Turn on/off the power supply.
V1.3 11/2021
7/22
Publicité
