Publicité
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the Woods dealer. It should be
delivered to the owner completely assembled, lubricated, and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly will be easier if aligned
and loosely assembled before tightening hardware. Recommended torque val-
ues for hardware are located in the Bolt Torque Chart, page 38.
Complete Dealer Check Lists, page 14 when you have completed the assem-
bly.
DANGER
DANGER
Full chain, rubber, or steel band shielding must be installed when
operating in populated areas or other areas where thrown objects could
injure people or damage property.
•
If this machine is not equipped with full chain, rubber, or steel
band shielding, operation must be stopped when anyone comes
within 300 feet (92 m).
1. A-Frame bar
2. Upper mounting hardware
3. Break link
4. Lift arm
5. Break link pivot hardware
6. Shield
7. Tailwheel
8. Rubber belting
9. Tailwheel bracket
DISASSEMBLE SHIPPING UNIT
(FIGURE 26)
Remove cutter from pallet or wood block.
Remove all parts that are zip tied to cutter.
MAN1253 (3/15/2018)
ASSEMBLY
9
2
Figure 26
. Shipping Configuration
•
This shielding is designed to reduce the risk of thrown objects.
The mower deck and protective devices cannot prevent all objects
from escaping the blade enclosure in every mowing condition. It is
possible for objects to ricochet and escape, traveling as much as 300
feet (92 m).
W W ARNING
Make sure attachment is properly secured, adjusted, and in good
operating condition.
CAUTION
CAUTION
Always wear relatively tight and belted clothing to avoid getting
caught in moving parts. Wear sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing, and head; and respirator or
filter mask where appropriate.
6
5
7
ASSEMBLE CUTTER
(FIGURE 27)
Remove cap screws and flange lock nuts that are securing Lift Arms (4) and
Break Links (3) to cutter.
Remove cap screws and flange lock nuts that are securing Tailwheel Bracket
(9) to cutter.
Remove Upper Mounting Hardware (2) from A-Frame Bars (1).
Assembly 19
ARNING
3
4
1
8
Publicité
