Publicité
CROSSBAR INSTALLATION
1.
Using emery cloth (220 or finer), remove surface rust, Loctite
foreign material from hub, splined gearbox, vertical shaft, and crossbar
as shown in Figure 18.
Figure 18
2.
Install crossbar (2) on splined shaft. Install castle nut and cotter pin.
Torque nut to 271 N-m (200 lbs-ft).
3.
Install the blades using existing hardware. Torque blade pin nut to 610 N-
m (450 lbs-ft).
Figure 19
MAN1253 (3/15/2018)
UNIVERSAL JOINT REPAIR
®
and
1. Yoke
2. Cup and bearing
3. Snap ring
4. Journal cross
Figure 20
U-Joint Disassembly
1.
Remove external snap rings from yokes in four locations as shown in
Figure 21.
2.
With snap rings removed, support drive in vise, hold yoke in hand and tap
on yoke to drive cup up out of yoke. See Figure 22.
3.
Clamp cup in vise as shown in Figure 23 and tap on yoke to completely
remove cup from yoke. Repeat Step 2 and Step 3 for opposite cup.
Dealer Service 17
. Universal Joint Parts Breakdown
Figure 21
. Remove Snap Ring
Figure 22
. Remove Cups
Publicité
