Publicité
Modello - Model - Modèle
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
INSTRUCTIONS FOR TECHNICAL SUPPORT
TECHNICAL SUPPORT: Specialist staff and staff responsible for installation and technical support
operations on the vending machine.
The following instructions are strictly the responsibility of technical support.
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention
on the flammable refrigerants.
ATTENTION! Use protective shoes and gloves during maintenance operations.
17. PLACEMENT AND LEVELING OF THE MACHINE
The equipment has 4 adjustable feet.
The leveling can be obtained using a 33 mm wrench.
It is strictly necessary after positioning to stabilise the equipment on the ground.
18. INSTALLATION OF PAYMENT SYSTEM
The vending machine is pre-set for the installation of a number of payment system:
•
Banknote reader;
•
Credit Card reader;
•
Key reader;
•
Coin acceptor/change return reader;
•
Coin validator.
The payment system must comply with the safety specifications of the international standards applicable
to the product.
The distributor is supplied without any payment system, it will be the responsibility of the installer to provide for its
assembly.
After installing your required payment system, the programming menu must be adjusted, by setting the parameters
corresponding to your selected payment system (see Programming manual).
The Manufacturer shall not be held responsible for any damages to the vending machine, persons and/or
property resulting from wrong installation of the payment system.
19. REGLAGE DE LA TEMPERATURE
Each refrigerating appliance is provided with an electronic control
for automatic maintenance of the temperature inside the tank.
This temperature adjuster is gauged by the factory and should
not be touched by the user.
Only if the average internal temperature is too cold or not cold
you can proceed as follows:
1. Press for two times the (Set) key in order to see on
display the temperature set point.
2. Press the (
) key or the (
increment or decrement the temperature set point
3. Press the (Set ) key in order to store the new tempe-
rature set point.
Defrosting is automatic on display tank.
If you want to set a manual defrosting, just defrost the unit
manually by pushing for at least 5 sec. the (
electronic control.
BROOKLYN PRO
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
) key in order to
) key of
2 7 / 8 8
PAGE
UM000761
N° DOC
Publicité
