Publicité
USING THE NINJA® NUTRI-BLENDER
IMPORTANT: Review all warnings at the beginning of this Owner's Guide before proceeding.
1 Plug in power pod and place on a clean, dry, level
surface such as a countertop or table.
2 Add ingredients to the Ninja Cup. DO NOT add
ingredients past the MAX LIQUID line on the cup.
4 Turn cup upside down so the bottom of the
blade assembly is flat on the worktop.
5
6
When blending is complete, lift up the cup to remove.
7
Turn cup over so blade assembly is on top. Twist blade
assembly counterclockwise to remove. To take your blended
contents on the go, place the spout lid on cup and turn
clockwise to seal. Do not store with the blades attached.
ninjakitchen.ca
3 Place the Blade Assembly on the top of the cup and turn
clockwise to seal.
Place the cup on the power pod. Press down on the cup
to pulse or blend.
CARE & MAINTENANCE
CLEANING
1
Separate all parts.
2
Wash all containers in warm, soapy water with a soft cloth.
Hand-Washing
Wash cups, lids, and blade assembly in warm, soapy water. Use a dishwashing utensil with a handle
to avoid direct contact with the blades. Exercise care when handling the blade assembly as the
blades are sharp. Thoroughly rinse and air-dry all parts.
Dishwasher
Cups, lids, and blade assembly are dishwasher safe. Ensure the blade assembly and lid are removed
from the cup before placing in the dishwasher.
Power Pod
Unplug the power pod before cleaning. Wipe power pod with a clean, damp cloth.
NEVER directly spray the pod with water or other liquids.
DO NOT use abrasive cloths/pads/brushes to clean the pod, as this can dull or scratch the surface.
RESETTING THE MOTOR THERMOSTAT
This unit features a unique safety system that prevents damage to the motor and drive system should
you inadvertently overload it. If the unit is overloaded, the motor will be temporarily disabled. Should
this occur, follow the reset procedure below.
1
Unplug the power pod.
2
Allow the power pod to cool for approximately 15 minutes.
3
Remove the blade assembly. Empty the container and ensure no ingredients are jamming
the blade assembly.
IMPORTANT: Ensure that maximum capacities are not exceeded. This is the most typical cause of
appliance overload.
ORDERING REPLACEMENT PARTS
To order additional parts and accessories, visit ninjakitchen.ca/page/parts-and-accessories or contact
Customer Service at 1 855 520-7816. So we may better assist you, please register your product online at
ninjakitchen.ca/register/guarantee and have the product on hand when you call.
ninjakitchen.ca
Publicité
