Télécharger Imprimer la page

Peavey PV i 6500 Mode D'emploi page 22

Publicité

Media Input
XLR BALANCED INPUT
9
Channel 6 is designed specifically for pre-recorded (pro-
gram) music, but can also be used with a microphone.
This XLR input provides a balanced low impedance con-
nection.
MIC OR MEDIA SELECT BUTTON
10
This control selects between the low impedance XLR (9)
and the RCA / 1/8", or USB MP3/Bluetooth® input .
11a/11b. MEDIA INPUT
11a
These RCA and 1/8" inputs accept a stereo input from
11b
the output of an MP3 player, CD player, tape deck or
other similar device.
®
FLS
12
When feedback occurs, the LED of the frequency closest
to the frequency that is feeding back will illuminate over
the slider to be adjusted. Slowly bring the corresponding
slider down until feedback is gone. The LED will remain
illuminated for a few seconds after the feedback is gone.
GRAPHIC EQ
13
These 9-band EQs are designed for 12dB cut or boost.
These EQs are used to make minor adjustments to the
overall mix and should be used sparingly.
AMP LEVEL LED LADDER
14
These LEDs indicate the signal level going to the power
amplifier. The top LED indicates LIMIT and activation
of our revolutionary DDT
Peavey's award winning speaker protection circuit is built
®
6500MP3 and activated automatically to
into the PV
maximize the power amplifier without fear of distortion.
POWER AMP INPUT SELECT
This control allows the user to select whether the 2nd
15
power amplifier receives its signal from the Master Vol-
ume (17) control or from the Monitor Volume (16) control.
This allows the user to run both power amps for mains at
the same level, or use power amp 1 for mains and power
amp 2 for monitors with independent level controls.
MONITOR VOLUME
An independent volume control that is active only when
16
switch 15 is placed in the LEFT position. This allows the
user independent volume control over the two internal
power amplifiers. This is especially convenient when us-
ing power amp 2 to drive monitor speakers.
MASTER VOLUME
The master level control for the main mix and the overall
17
volume of the powered mixer. When switch 15 is in the
RIGHT position, the master volume controls both internal
power amplifiers.
speaker protection circuit.
9
11a
14
15
16
10
11b
12
13
17

Publicité

loading