Publicité
2. Fit 2 Short Shelf Supports and 2 Long Shelf Supports to the
bottom boles (for maximum strength) of 4 Keyhole Uprights by
slotting the Keylock Pins in the Supports into the Uprights and
tapping firmly with a hammer to seat in place (Pic 2).
Pic 2
3. Fit Long and Short Shelf
Supports where you want the
2nd Shelf to be positioned.
These Supports must not be
in the top 2 holes of the
Keyhole Upright. (Pic 3)
(We have shelf position
recommendations listed
below).
SHELF POSITION RECOMMENDATIONS
NUMBER OF HOLES
ON KEYHOLE
UPRIGHT BETWEEN
SHELF SUPPORTS
04
LONG SHELF
SUPPORT
FIT TO BOTTOM HOLES
SHORT SHELF SUPPORT
SHELE SUPPORTSFOR
2ND SHELF
Pic 3
4. (GO TO 5 IF YOU ARE NOT ASSEMBLING AS A WORKBENCH)
a) Fit 2 Long Shelf Supports for the top of the Workbench into the
holes at the top of the Keyhole Uprights and fit 1 Centre Brace to
these Shelf Supports.
b) Use the remaining Keyhole Uprights, Long and Short Shelf
Supports and Centre Braces to maker either a Straight Workbench
or a Corner Workbench, using the same method as above.
c) Install Wire Shelf.
d) Bolt the 2 halves of the Workbench together if needed (nuts and
bolts not supplied).
STRAIGHT
WORKBENCH
5.To make one side of
the top half of the
Storage Unit: Fit 3 Short
Shelf Supports to 2
Keyhole Uprights. Fit the
top Support first. It must
be located in the 2 holes
of the Upright. Then fit
the 4th Support and
lastly the 3rd Support to
the bottom hole of the
Upright.(Pic 4)
Repeat this procedure to
make the second side.
Fit these 2 top halves to
the bottom half of the
Unit.(Pic 4)
CORNER
WORKBENCH
KEYHOLES TO RE
THIS WAY UP
FIT SUPPORT TO BOTTOM
HOIE OF UPRIGHT
Pic 4
TOP SHELE
SUPPORT
4TH SHELF
SUPPORT
3RD SHELF
SUPPORT
05
Publicité
