Publicité
PW 0620
1/2" IMPACT WRENCH 620Nm 20V BRUSHLESS
PW 0621
4. During charging, it is normal for the battery to warm slightly. If you cannot discharge the battery
check:
- That the electrical outlet has voltage.
- That the charger contacts are undamaged and making contact with battery leads.
BATTERY CAPACITY INDICATOR
You can check the battery's power status by pressing the power display button on rear of the
battery.
- All LEDs Illuminated: The battery is fully charged.
- Yellow and red LED illuminated: The battery has an adequate remaining charge.
- Red LED: The battery is empty, recharge the battery.
You can charge the battery through the modular charging port. The input is a maximum of 13v at
1.5 mA. This will take approximately 1.5 hours at maximum input. This adapter is not included.
LED LAMP
Toe LED lamp can be used in poor lighting conditions to illuminate the work area. The LED lamp
will light up as soon as you press the trigger.
OPERATION
BEFORE USE
Important! Always lock the trigger switch and remove the battery from machine before doing any
work on the machine!
INSERTING BATTERY INTO THE TOOL
Set the rotational direction switch to the center position to protect the power tool against
accidental starting. Insert the charged battery into the handle so that it can be felt to engage and
faces flush against the handle.
OPERATING THE TOOL
To activate the tool, press the Trigger and Keep it pressed. To switch off the machine, release the
trigger.
The trigger is variable speed and the speed depends on the amount of pressure you apply to the
trigger. Light pressure on the trigger results in a low rotational speed. Further pressure on the
switch results in an increase in speed.
FORWARD (CLOCKWISE) OPERATION:
The motor has an electronic clutch with three different forward speed settings: 1, 2, and 3 (low,
medium and high).
The speed setting is adjusted by pushing the button on the Electronic clutch control panel on the
base of the tool. If the trigger is momentarily pushed the Electronic Clutch will be activated. If
one green LED is illuminated, the motor is set to Speed 1. If two green LEDs are illuminated then
the motor is set to speed 2 and three green LEDs for speed 3. Push the button marked on the
Electronic clutch control panel to cycle through the three speed settings and select the correct
one for your specific application.
1st Speed
2nd Speed
Reverse
Speed
RPM
0-1700
0-2500
0-2500
BPM
0-2500
0-3600
0-3600
Publicité
