Publicité
64
Problem
The sensor fields become
hot.
comes on.
comes on.
and a number come on.
You can hear a constant
beep noise.
comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
TECHNICAL DATA
Rating plate
Model DKEV6646XB
Typ 60 HAD 47 AO
Ser.Nr. .................
Dieter Knoll Collection
Possible cause
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
Child Safety Device or Lock
operates.
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 492 323 00
220 - 240 V 50 - 60 Hz
Made in Romania
7.0 kW
Remedy
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If
comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.
Publicité
