Publicité
ASSEMBLY INSTRUCTIONS
Remove all loose parts from the inside of the grill
and hopper. Lay a blanket or piece of cardboard
down to protect the grill.
ATTACH THE LEGS
With the help of another person flip the grill upside
down on the blanket or cardboard. The grill lid and
hopper lid will swing open when doing this so be
careful not to damage the lids. The grill may also
want to roll on its lid so one person should hold the
grill steady while the other person assembles the
bottom legs and wheels.
1. Assemble the legs as shown in Fig. 1. Finger
tighten hardware.
2. With the help of another person, stand the grill
upright. Be careful as the lid on the hopper and
grill will close as the grill is stood upright.
3. Tighten all hardware assembled in the previous
steps.
INSTALL HANDLE
1. Install the handle as shown in Fig 2.
2. Tighten all hardware.
FIG. 2
FIG.1
M8 X 20 BOLT
M8 LOCK WASHER
DRIP TRAY
HEAT DEFLECTOR
M6 FLAT WASHER (2)
M6 LOCK WASHER (2)
M6 NUT (2)
GREASE BUCKET
1. Hang grease bucket from tube as shown in Fig 6.
INSTALL DRIP TRAY
1. Install the Drip Tray as shown in Fig 7 and Fig 8.
WARMING RACK AND COOKING GRATE
1. Install the cooking grate as shown in Fig 9.
FILLING THE AUGER TUBE
CAUTION: ONLY USE THE FEED SETTING WHEN
HOPPER HAS RUN OUT OF PELLETS. FEED SETTING
IS NOT FOR NORMAL USE.
The first time you use your grill or any time the
hopper has ran out of pellets you will need to fill
the auger tube. This simply means you must fill
the auger tube with pellets until pellets reach the
GREASE BUCKET
FIG. 6
DRIP TRAY
FIG. 7
DRIP TRAY
HEAT DEFLECTOR
FIG. 8
WARMING RACK (OPTIONAL)
NOT INCLUDED
COOKING GRATE
FIG. 9
Publicité
