Publicité
3. To use the unit as a telescoping pole pruner, balance your
weight with both feet on solid ground and hold the pole
pruner by one hand on the rear handle and the other on
the pole. Position the unit at a proper angle depending on
the specific situation (Fig. 14).
Fig. 14
TELESCOPING POLE
PRUNER MODE
4. Take the proper stance in front of the tree with the pruner
off and press the safety lock button on the rear handle.
When you are ready to make a cut, squeeze the trigger
switch to close the blades. After the cut, release the
trigger. The pole pruner will return to the (open) starting
position (Fig. 15).
Fig. 15
Safety lock button
Trigger switch
m
CAUTION!
Always ensure proper footing and balance
in a clean and clear work environment before switching on the
cordless pruner.
TELESCOPING POLE
PRUNER MODE
Adjusting the Telescoping Pole (Optional)
When being used as the telescoping pole pruner, the machine
is equipped with a telescoping pole which provides up to an
additional 5.83 ft (1.78 m) of overhead reach. To adjust the
telescoping pole, follow the instructions below.
1. Release the trigger switch and the safety lock button.
Remove the battery from the compartment. Wait until the
tool has stopped completely.
2. Flip up the telescoping pole cam-lock, and extend the
pole to the desired length (Fig. 16).
Fig. 16
Telescoping pole
cam-lock
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb to be cut.
3. Lock the pole in position by closing the cam-lock, and
ensure that the pole is secure.
Adjusting the Cutting Angle (Optional)
The pole assembly is also equipped with a rotating function
that will enable the pruner to cut in any of 7 positions. (-45º,
-22.5º, 0º, 22.5º, 45º, 67.5º, 90º) (Fig. 17). To adjust the cutting
angle, follow the instructions below.
Fig. 17
90°
1. Release the trigger switch and the safety lock button.
Removed the battery from the compartment. Wait until the
tool has stopped completely.
12
Telescoping pole
-45°
-22.5°
0°
22.5°
45°
67.5°
Publicité
