Publicité
INSTALLING THE REFRIGERATOR (cont.)
REINSTALL REFRIGERATOR
3
DOOR (Cont.)
H.
top left of the refrigerator door. Make sure
the door is aligned with the cabinet. Attach
the hinge to the top of the cabinet loosely
with the bolts that were removed previously.
Make sure the gasket
on the door is flush
against the cabinet
and not folded.
Support the door on
the handle side and
make sure the door is
straight and the gap
between the doors is
even across the front.
While holding the
door in place, tighten
the screws to 60 in-lb.
(6.78 Nm).
For Models with a Freezer DRAWER:
I. Remove the front insert from the left hinge
Phillips screwdriver and the screw removed
earlier.
J.
Phillips screwdriver and the screws removed
earlier.
For Models with a Freezer DOOR:
I. Locate the left hinge
cover that comes
Phillips screwdriver,
install the cover with
the screws provided.
49-1000472 Rev. 3
Installation Instructions
insert
REINSTALL REFRIGERATOR
3
DOOR (Cont.)
J. Locate the insert for the right hinge cover that
comes with the kit and install.
K.
hinge cover with screws provided.
4
TRANSFER HANDLE
MOUNTING FASTENERS
A. Remove the plug from the lower right whole.
B.
screws holding the mounting brackets from
the left side and install them on the right side.
Remove plug
INSTALLING LOGO BADGE
5
A. Locate the new logo
badge from the kit.
Remove the adhesive
backing paper and align
the pins on the back
of the badge with the
holes in the door. Apply
pressure to the badge to
ensure it sticks to the door.
B. Locate the button plug from
the kit and install it in the
opposite side of handle.
35
Publicité
