Publicité
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
it will not run often enough to maintain proper
temperatures.
will not perform properly.
to water (rain, etc.) or direct sunlight.
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
IMPORTANT NOTES
This refrigerator without the handles ranges from
your model (see dimension G on the previous page).
to leave the doors attached to the refrigerator
while transporting it into the installation location.
refrigerator doors can easily be scratched and
damaged. The doors can be removed to allow the
refrigerator to be safely moved indoors.
•
•
single refrigerator door model, see Reversing the
•
•
see
•
NOT necessary to remove doors, skip to
Page 31. Leave tape and all packaging on doors
until the refrigerator is in the final location. Once in
place, install door handles (see Steps 1 and 2).
• SKID REMOVAL: Tilt refrigerator to each side to
remove skid.
• NOTE:
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
49-1000472 Rev. 3
Installation Instructions
(91.4 cm), the
Removing
ATTACH REFRIGERATOR
1
HANDLES
Attach refrigerator handle to the mounting
fasteners by aligning the slots on the handle with
the mounting fasteners. Slide the handle down
until it comes to a hard stop.
NOTE:
Mounting
follow the same
procedure for both
doors.
Verify handle is
securely attached
by pulling handle
upwards.
2
ATTACH FREEZER HANDLE
WARNING
may allow the handle to detach when it is used to
while in use may cause the user to lose their
balance, which creates a fall risk.
by aligning the slots inside the handle endcap with
the mounting fasteners. Being careful to avoid
scratching the door finish, slide the handle to the
right until it comes to a hard stop.
Slot
Endcap
with a towel wrapped around head of hammer
can be used as well), to gently tap the left side
of handle until the handle no longer moves left or
right. A few taps should be used rather than
using heavy force witch can cause handle/
endcaps to get damaged.
25
Publicité
