Publicité
Filling The Rinse Aid Reservoir
A
Press this button as shown in the
figure, and the lid of the rinse aid
will open automatically.
С
Close the cap after all.
3
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1.
Open the door, switch on the appliance
2. Within 60 seconds after the appliance was switched on press the Program button
for more than 5 seconds, and then press the Delay button to enter the set model,
the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button again to select the proper set according to your using
habits, the setting will change in the following sequence: d3->d4->d5->d1->d2->
d3. The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to complete the setup
and exit the setting mode.
B
Pour the rinse aid into the dispenser,
being careful not to overfill.
NOTE:
The rinse aid used in dishwashers is a
special product that is recommended
to increase drying efficiency and
prevent water or lime stains on the
washed items.
For this reason, care must be paid to
have rinse aid in the rinse aid reservoir
and to use rinse aids produced
specially for dishwashers only.
.
12
Publicité
