Publicité
USE
1.
Unwind the cord to a substantial length and plug in the vacuum cleaner. The yellow label on the cord
indicates the maximum length of the cord, that should not be exceeded.
2.
To turn the vacuum cleaner on and off, press the foot pedal with the
3.
The suction power can be regulated in 2 ways:
·
Electronically: press the "+"and "-" buttons on the appliance. The indication lamps indicate the
suction power.
·
Mechanically: open or close the slide on the grip of the hose.
4.
The vacuum is suitable for all floors. The switch on the mouth of the floor suction head folds in the
wheels for vacuuming carpet.
5.
When you have finished vacuuming, unplug the vacuum cleaner and automatically rewind the cord
by pressing the foot pedal with the
sure that the plug does not whip back and forth while rolling the cord up. This to prevent possible
damage.
CLEANING AND MAINTENANCE
CHANGING THE DUST BAG
The vacuum cleaner cannot be used without the dust bag. When the dust bag is full
or damaged you need to replace it immediately.
·
Remove the flexible hose.
·
Pull the clip of the lid of the dust bag to open it.
·
Remove the dust bag and place a new one in the correct position.
THE FILTERS
The appliance has 2 filters. In a normal cleaning session, it is sufficient to tap out the filters. It is
recommended that you thoroughly clean the filters under tepid running water 3 to 4 times per year.
Make sure that it is completely dry before putting it back in the appliance. You can also replace them if
necessary. Avoid direct sunlight or intense overheating. Never put the filters in the washing appliance to
prevent deformation. Do not use abrasive or cleaning products and wash from the bottom of the filter.
HEPA filter
On the back of the appliance there is a grille for the HEPA filter. This can be easily
removed by pushing the clips of the grille down and removing the grill from the
appliance. Take the HEPA filter out of the appliance by pulling the clip to the left.
It is recommended that this filter be replaced once a year.
Motor filter
The motor filter is located in the dust bag compartment.
Remove the flexible hose. Press the button on the lid of the dust bag to open it.
Open the filter holder and remove the filter. Clean it thoroughly. Allow it to air-dry
properly. Replace it in the vacuum.
PLEASE NOTE:
·
Make sure that all components are correctly assembled before using the
vacuum cleaner again.
www.domo-elektro.be
symbol. Hold on to the plug at the end of the cord to make
symbol.
DO1007S
21
Publicité
