Publicité
1. Connect the device according to the wiring diagram.
NOTICE! Damage hazard
Use cables with a section of at least 16 mm² and protect the house battery and also the starting
battery with a 80 A fuse. This may be increased in case of special needs.
The maximum current of appliances or chargers that can be connected to pin.2 is 100 A. Higher
load thresholds (such as inverters or energy-hungry appliances) may damage the device.
NOTE The wiring diagram shows an example
Not all these electrical devices have to be connected for the device to work.
See operating manual for each electrical device for correct wiring of that specific product.
2. The LED indicator blinks to show that the loads are connected to the battery. If the LED indicator does not blink
aer wiring, press the on/off button for 1 second to activate the battery connection.
7 Operation
If the battery has been disconnected because of low voltage, connect a charging source to the battery to connect
it again. As soon as enough state of charge has been reached in the battery, the LED indicator flashes and is then
turned on. The battery connects and supplies the loads with power.
Charging of the house battery can also be done by running the engine to let the alternator charge the battery.
To manually disconnect the battery, press the ON/OFF button. The LED indicator flashes and is then turned off.
The battery disconnects from supplying the loads with power.
To manually connect the battery, press the ON/OFF button. The LED indicator flashes and is then turned on. The
battery connects and supplies the loads with power. The battery voltage must be over 10.5 V for this action to
work.
8 Cleaning and maintenance
The device is maintenance-free.
Occasionally clean the product with a damp cloth.
9 Storing
If the vehicle is unused for a longer period than 30 days, disconnect the ground cable of the device to delete all
possible current absorption that may deep discharge the house battery.
10 Warranty
The statutory warranty period applies. If the product is defective, please contact the manufacturer's branch in your
country (see dometic.com/dealer) or your retailer.
For repair and warranty processing, please include the following documents when you send in the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or nonprofessional repair can have safety consequences and might void the warranty.
EN
7
Publicité
