8.1 Using the detergent
A
B
C
CAUTION!
Only use detergent specifically designed
for dishwashers.
1. Press the release button (A) to open the
lid (C).
2. Put the detergent (gel, powder or tablets)
in the compartment (B).
3. If the programme has a prewash phase,
put a small quantity of detergent on the
inner part of the appliance door.
4. Close the lid. Make sure that the lid locks
into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a load
with normal soil.
The upper ends of the two vertical ribs
inside the compartment (B) indicate the
maximum level for filling the dispenser
with gel (max. 30ml).
8.2 How to select and start a
programme using MY TIME
selection bar
1. Slide your finger across MY TIME
selection bar to choose a suitable
programme.
• The light related to the selected
programme is on.
• The ECOMETER indicates the level of
energy and water consumption.
• The display shows the programme
duration.
2. Activate applicable EXTRAS if desired.
3. Close the appliance door to start the
programme.
8.3 How to activate EXTRAS
Options must be activated every time before
you start a programme. It is not possible to
activate or deactivate options while a
programme is running. Not all options are
compatible with each other.
1. Select a programme using MY TIME
selection bar.
2. Press the button dedicated to the option
you want to activate.
• The light related to the button is on.
• ECOMETER and programme duration
are updated.
Activating options often increases water
consumption, energy consumption and
programme duration.
8.4 How to start the AUTO Sense
program
1. Press
.
• The light related to the button is on.
• The display shows the longest
possible program duration.
2. Close the appliance door to start the
program.
The appliance senses the type of load and
adjusts a suitable wash cycle. During the
cycle, the sensors operate several times and
the initial program duration can decrease.
8.5 How to delay the start of a
programme
1. Select a programme.
2. Press
repeatedly until the display
shows the desired delay time (from 1 to
24 hours).
The light related to the button is on.
ENGLISH
15