Extraction - Frigomat T4s 06 Série Manuel D'utilisation Et D'entretien

6.4 EXTRACTION

27 - ENGLISH
To extract the product at the end of a productive
cycle, refer to the following instructions:
- Position cold and clean tub of adequate capacity
on the front shelf of the machine.
- Check that the production cycle has ended.
- T4S model : rotate the steel lever connected to
the dispenser disk anti-clockwise to the right.
T5S model : rotate the steel lever connected to
the dispenser disk clockwise to the left.
- When the product starts coming out of the door
safety grid, press the EXTRACTION key to disable
the compressor in order to prevent ice from
forming on the cylinder walls in the emptying
phase. The EST message is viewed on the
display.
Always remember to disable the compressor right
from the first extraction phases to prevent premature
wear of the scrapers.
- When all the product has come out of the door,
press the STOP key to stop the machine and re-
close the dispenser disk.