Frigomat T4s 06 Série Manuel D'utilisation Et D'entretien page 63

Fig.1
Fig.2
Fig.3
Fig.4
In order to correct any initial programming errors,
during the execution of the GR1 cycle it is always
possible to vary the consistency setting via the
following procedure:
- With the cycle in progress, press the SLUSH key
(Fig.1) once.
- The LEDs of the UP, Confirm and DOWN keys
light up and the GR1 message relative to the cycle
in progress is viewed on the display (fig. 2-3).
- Press the SLUSH key again.
- The numbers relative to the previously configured
consistency setting appear on the display: press
the UP and DOWN keys to correct the value.
- Press the CONFIRM key to validate the new data
and exit programming (fig. 4).
ENGLISH - 24