ION iLP Guide D'utilisation Rapide page 4

FEATURES
1. Platter – Place your record here.
2. Tonearm – The tonearm can be raised and
lowered by hand, or by pressing the raise / lower
lever. Please note that the tonearm needs to be
moved away from resting position (on the arm
clip) for the turntable motor to activate. When the
tonearm is placed back in its resting position, the
turntable motor will deactivate if Autostop has
been turned on.
3. Arm Clip – This specially designed arm clip
secures the tonearm while at rest or when not in
use. The arm clip has been designed to remain
in the up position while unlocked.
4. Raise / Lower Lever – Raises and lowers the
tonearm.
5. 33 / 45 / 78 Switch* – This switch controls the
RPM of the turntable platter.
6. Autostop switch – This switch turns autostop on
or off. When autostop is on, the platter will start
spinning when the tonearm is placed over the
record and stop spinning when the record has
reached the end. (When autostop is off, the platter
will always spin regardless of the position of the
tonearm.)
7. Dock – Connect your iOS device (not included) here to
record audio to it from your vinyl. Please see the
USING iLP WITH YOUR iPhone, iPad, or iPad touch
section of this manual for information on compatible iOS
devices and how to record to them.
8. RCA Output** – The audio from a playing vinyl record
is sent to this line-level coaxial audio output. This must
not be connected to phono level devices.
9. USB Audio Output – Use the included USB cable to
connect your turntable to your computer. The USB
connection will send audio from the turntable to your
computer. Please see the USING iLP WITH YOUR
COMPUTER section of this manual for information.
10. Power – Use the included adapter to connect to wall
power.
11. Power Button – Press this button to turn iLP on/off.
7 7
IMPORTANT:
cartridge cover (needle cover) before
operating the turntable.
**WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
* If needed, you may adjust the speed of
the turntable platter. On the underside of
iLP, remove
tighten/loosen the appropriate screw with
a screwdriver.
4
7
7 2
7 1
7 3
DC 12V 1A
10 11
Mac/PC
8 9
Remove the plastic
the rubber pads
7 4
7 5
7 6
and