Publicité
Description of the device
For the illustrations, refer to the graphics page.
Illustration A
Operation button for Device On / Off
1
Operation button for Function lock
2
Display PM 2.5 Air quality index
3
Operation button for Switch off display
4
Display for fan level
5
Operation button for Auto mode On / Off
6
Fan level operation button
7
Operation button for Sleep mode On / Off
8
Timer display
9
Operation button for Timer
10
Filter service life display
11
Operation button for Filter reset
12
Air quality display and device display
13
Filter cover lock
14
Filter cover
15
Filter tab
16
filter
17
Connection for power supply unit
18
Device sensor
19
Power adapter
20
Note
The function settings are only possible via the operation
buttons and not via the displays.
Inserting the filter
Before initial start up, the fine filters already installed in
the unit must be unpacked.
1. Turn the device over, and turn the filter cover lock 45
degrees clockwise.
Illustration B
2. Remove the filter cover.
Illustration C
3. Remove the packed filters.
Illustration D
4. Unpack the filters.
Illustration E
5. Insert the unpacked filters. Ensure that the draw
shackles are visible and point inwards.
Illustration F
6. Put on the filter cover and turn the lock 45 degrees
anticlockwise. Turn the device over with the display
facing upwards.
Illustration G
7. Place the device on a level surface. Ensure that a
distance of 30 cm is maintained to each side.
Illustration H
Note
Do not place the device on hot surfaces or in the imme-
diate vicinity of the room heating.
Do not allow any liquids or foreign bodies (e.g. metallic
objects) to enter the device.
8. Insert the plug of the power supply unit into the de-
vice and insert the mains plug into the socket.
Illustration I
The device is ready for operation.
Note
The first time you use the device, we recommend allow-
ing it to run overnight to perform an initial basic cleaning
of your room.
Note
The table with the hours of the display symbols for the
filter service life, see Replacing the filter
Switching the device on/off
1. To switch on the device: Press the on/off button on
the device.
Illustration I
The device starts automatically.
Note
After the system is switched on, the displays and but-
tons on the control panel light up briefly. The integrated
air quality sensor measures the air quality in the room
automatically.
2. If required, the following functions, for example, can
be set via the operation buttons:
Fan level
Auto mode
Sleep mode
Timer
3. To switch off the device: Press the On/Off switch of
the device.
The displays and buttons on the control panel go
out. The device is switched off.
In automatic mode, the air purifier sets the appropriate
fan level depending on the air quality.
In the event of poor air quality, for example, the fan level
is automatically set high.
Symbol for the auto mode operation button:
Press the auto mode operation button. The auto-
matic mode is switched on or off.
In sleep mode, the fan runs at the lowest speed and is
therefore very quiet. All light symbols are off.
● Press the sleep mode operation button. The sleep
mode is switched on or off.
Symbol for the sleep mode operation button:
Depending on the air quality, the fan level can be man-
ually set to level I, II or III. If the air quality is poor, for ex-
ample to filter out smoke, the blower should run at
maximum speed (level III) for 15 - 20 minutes.
Note
To clean the air effectively, keep windows and doors
closed while the air purifier is switched on.
Symbol for the fan level operation button:
English
Operation
Setting auto mode
Setting sleep mode
Setting the fan level
9
Publicité
