Helios Radiant HP1/10 Mode D'emploi page 11

compliance with the applicable regulations and equipped with an
efficient earthing system. If in doubt, have a qualified electrician perform
a thorough check.
 The appliance must be installed by a professional technician, according
to
the instructions given in this booklet. Star Progetti cannot assume any
responsibility for damage to property or personal injury resulting from
failure to abide by the instructions given in this booklet.
Use a multi-polar switch with minimum contact gaps of 3 mm when
installing the appliance.
Connect the appliance to the electrical power supply only if the system
is able to provide the maximum electrical voltage and capacity
indicated on the rating plate at maximum power.
Before carrying out any type of cleaning or maintenance operation,
turn the appliance off and turn the main power switch off to disconnect
it from
the power supply.
Should the appliance be dropped or suffer a heavy blow, have it
checked immediately by Star Progetti.
 When carrying out maintenance operations, never touch the bulbs
directly, but only the terminal casings. The bulb will be damaged by
contact with naked hands; in this eventuality the product guarantee will
no longer be considered valid.
In the event of accidental contact with the surface of the bulb, clean
it immediately by wiping with a cloth dipped in denatured alcohol.
 If the appliance does not function correctly or develops a fault, turn it
off
and contact Star Progetti immediately.
Ensure that only genuine original Star Progetti spares are used for
any repairs. If the cable or the power plug are damaged, take the
appliance to an authorised Star Progetti service centre for replacement.
Use a cable with T180 characteristics.
 Switch off the appliance at the main switch: a) if the appliance does
not
function correctly; b) before cleaning the outside of the appliance; c) if
the appliance is not to be used for long periods of time.
 Do not cover or block the appliance during use.
In order to avoid creating a fire hazard, the appliance must never be
installed with the radiating elements close to or facing towards
curtains, beds or other objects or materials that are liable to burn
easily; always ensure that these objects are at a suitable minimum
distance, to avoid any risk of fire or heat damage.
Never use the appliance in combination with programming devices,
timers
or other devices that will switch it on and off automatically.
11