SOMFY ILT 2 Notice D'installation Et D'utilisation page 9

10m
Wiring with
dry contact
10m
Wiring with
IR contact
1.5m
Wiring with
Digital
Network
Commissioning
The ILT actuator is delivered without pre set end limit. A specific setting tool is
needed to adjust the end limit.
Check polarity
Connect the setting tool to the actuator
with the phone cable.
The LED lights on.
Put the selector upward.
Press the UP or DOWN push button of
the setting tool to check polarity.
If the direction is wrong, press the STOP
button more than 2 seconds.
Copyright © 2009-2016 Somfy SAS. All rights reserved
10m
10m
10m 10m
S T O P
S T O P
1.5m
BIU-2ILT
R R
ST OP ST OP
7