Publicité
How to dismantle parts
Separate the lamp by pulling it out ➂ while slightly
Freezer
pressing ➀ and rotating ➁ the lamp cover.
compartment
lamp
Turn the bulb counterclockwise. Use a 40-watt bulb
(max.) which can be purchased at a service
center.
Freezer
To remove a shelf, push the shelf to the left ,
lift the left part of the shelf a bit ➀, lift the right
compartment
part up ➂ , and take it out.
shelf
Door rack and
Lift the door rack holding both sides
pull it out .
support
Ice storage bin
Hold the ice storage bin as shown in the right
figure and pull it out
After dispenser
The water collector has no self-draining
function. It should be cleaned regularly.
is used
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Pull the cover fully to the front ➀ and pull up
the rear end of the cover ➁ slightly to pull it out.
➂ Clean the floor and cover with a dry cloth.
20
NOTE
Dismantling is done in the reverse sequence of assembly.
•
Be sure to unplug the power plug before dismantling and assembly.
Never apply severe force to dismantle parts. Parts may be damaged.
while slightly lifting it
Do not dismantle the ice storage bin unless
it is necessary.
Use both hands to remove the ice bin to avoid
dropping it.
Care and maintenance
!
and
.
!
2
1
!
Publicité
