Publicité
Cleaning
Image Sensor
The image sensor is protected from contamination by protective glass.
However, the protective glass can be contaminated by dust and other
debris.
To clean the protective glass, perform the following steps:
1.
Remove the lens or dust cap.
2.
Using a photographic-grade bulb-type blower
(commercially available), blow away any dust or foreign
debris from the protective glass inside the lens mount.
3.
Immediately replace the lens or dust cap.
If the protective glass is still not clean, obtain an image sensor
cleaning swab and solution. Follow the cleaning instructions provided
by the manufacturer.
Avigilon recommends using the Type 2 Sensor Swab™ and Eclipse®
cleaning solution made by Photographic Solutions, Inc. For a
worldwide list of dealers, visit the Photographic Solutions, Inc. website
at www.photosol.com.
Caution —
•
Never touch the image sensor or any glass
elements inside the lens mount except with the
recommended cleaning tools.
•
Do not allow dust, moisture or any other foreign
debris to enter the lens mount.
•
Avoid leaving the image sensor exposed for
extended periods of time.
•
Always cover the image sensor with either a lens
or a dust cap.
11
Publicité
