Publicité
EN
CONNECTION
-
Place the receiver at least 1 metre away from the floor, walls or metal surfaces, and in an unobstructed
location so that the signal between your antenna and the microphone is as direct as possible.
-
Insert the batteries into the microphone and check that they are sufficiently charged. When the microphone
detects low power, the battery icon on the transmitter and receiver will indicate this.
-
Install the antennas on the receiver and position them vertically for best reception.
-
Connect the balanced audio outputs or the unbalanced mixed signal to the amplifier, mixer, etc.
-
Connect the power adapter to the receiver and then to the mains.
-
With the volume controls set to minimum, turn on the receiver.
-
Next, perform the receiver and transmitter synchronisation process with each microphone to set up their
transmit channels. For more information, see section OPERATING INSTRUCTIONS - RECEIVER AND
TRANSMITTER SYNCHRONISATION. At this point the RF indicators should be on. If this is not the case,
please refer to the INSTRUCTIONS FOR USE - PROBLEMS AND SOLUTIONS section.
-
Speak into the microphones and check that the AF indicators light up when you speak and adjust the
volume controls so that the red AF indicator does not light up continuously. If your problem is audio
related, please consult INSTRUCTIONS FOR USE - PROBLEMS AND SOLUTIONS section.
SONAIR-PRO-2M
SONAIR-PRO-2MP
AMPLIFIER
- 6 -
Publicité
