Publicité
b
3.- On the receiver, long press the SYNC button and the IR sensor will start flashing red indicating that it
is active.
4.- Place the IR sensor of your microphone in front of the IR sensor of the receiver.
5.- When the receiver's IR is synchronised, the receiver's IR will turn off, all RF channel LEDs will turn on,
and the microphone display will show the newly configured channel.
PROBLEMS AND SOLUTIONS
If the RF indicators do not light up, the AF indicators do not light up or the audio does not come through
CH
clearly to the receiver, this can be due to several causes:
B
MHz
-
the microphone batteries are dead. Replace them with new ones.
IR
-
the selected channel or another adjacent channel is being used by other equipment in the vicinity. Select
another channel and perform the synchronisation process again.
-
the distance between the microphone and the receiver is too great because it is too far away or because
the area where you are using the microphone is saturated with signals. You can use different solutions
to extend the signal strength by changing the antennas supplied with the equipment and thus extend the
coverage distance:
Antenna amplifier AMP-811 and antenna ADU-830.
-
-
Amplified antenna ADU-823AMP.
INSTALLATION IN 19" RACK
FONESTAR offers the possibility of installing this receiver in 1 U of a 19" rack cabinet with the supplied
mounting brackets.
Its installation is very simple as shown in the image:
A
B
A B
680.10
679.70
MHz
MHz
402
398
CH
CH
VOL 97%
VOL 76%
3 seg.
3 seg.
CHANNEL
MHz
A
B
A B
- 5 -
EN
Publicité
