Publicité
6.4 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
/
/
As long as the indicator is
visible, there is a risk of burns from
residual heat.
The induction cooking zones produce the
heat necessary for the cooking process
directly in the bottom of the cookware. The
glass ceramic is heated by the heat of the
cookware.
The indicators appear when a cooking zone
is hot. They show the level of the residual
heat for the cooking zones you are currently
using:
- continue cooking,
- keep warm,
- residual heat.
The indicator may also appear:
• for the neighbouring cooking zones even if
you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
6.5 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones adapt
to the dimension of the bottom of the
cookware automatically.
For optimal heat transfer use cookware
with bottom diameter similar to the size of
the cooking zone (i.e. the maximum
cookware diameter value in "Technical
data" > "Cooking zones specification").
Make sure that the cookware is suitable
for induction hobs. For more information
on cookware types refer to "Hints and
tips".
You can cook with large cookware placed on
two cooking zones at the same time. The
cookware must cover the centres of both
zones but not go beyond the area marking. If
the cookware is located between the two
centres, Bridge function will not be activated.
6.6 Bridge
The function operates when the pot
covers the centres of the two zones. For
more information on the correct
placement of cookware refer to "Using
the cooking zones".
This function connects two left side cooking
zones and they operate as one.
First set the heat setting for one of the left
side cooking zones.
ENGLISH
35
Publicité
