Publicité
16
!
CAUTION!
exist, do not use the gas grill. Have the part replaced by your Napoleon Grill dealer or qualified gas
EN
installer.
Aluminum Castings: Clean castings periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidation to occur on aluminum surfaces. This appears as white
spots on the castings. To refinish these areas, clean first and sand lightly with fine sandpaper. Wipe the
surface to remove any residue and paint with high temperature barbecue paint. Protect surrounding areas
from over-spray. Follow the manufacture's directions for curing.
Troubleshooting
Problem
Low heat / Low flame
when valve turned to high.
Excessive flare-ups/
uneven heat.
Burners burn with yellow
flame, accompanied by
the smell of gas.
Flames lift away from
burner, accompanied
by the smell of gas, and
possibly difficulties in
lighting.
Rear and Side burners will
not light with the igniter,
but will light with a match.
Main burner will not light
with the igniter, but will
light with a match.
www.napoleon.com
Check for abrasions, melting, cuts, and cracks in the hose. If any of these conditions
Possible Causes
For propane - improper lighting
procedure.
For natural gas - undersized supply line.
For both gases - improper preheating.
Sear plates installed incorrectly.
Improper preheating.
Excessive grease and ash build on sear
plates and in drip pan.
Possible spider web or other debris, or
improper air shutter adjustment.
Improper air shutter adjustment.
Dead battery / or installed incorrectly.
Loose electrode wire or switch terminal
wires.
Lifting flames on burner.
Jet-fire outlet is dirty or clogged.
Solution
Ensure lighting procedure is followed carefully.
All gas grill valves must be in the off position
when the tank valve is turned on. Turn tank on
slowly to allow pressure to equalize. See lighting
instructions.
Pipe must be sized according to installation code.
Preheat grill with both main burners on high for
10 to 15 minutes.
Ensure sear plates are installed with the holes
towards the front and the slots on the bottom.
See assembly instructions.
Preheat grill with both main burners on high for
10 to 15 minutes.
Clean sear plates and drip pan regularly. Do not
line pan with aluminum foil. Refer to cleaning
instructions.
Thoroughly clean burner by removing. See
general maintenance instructions. Open air
shutter slightly according to combustion air
adjustment instructions. (This must be done by a
qualified gas installer.)
Close air shutter slightly according to combustion
air adjustment instructions. (This must be done
by a qualified gas installer.)
Replace with premium heavy duty battery.
Check that electrode wire is firmly pushed onto
the terminal on the back of the igniter. Check
that the lead wires from the module to the
ignition switch (if equipped) are firmly pushed
onto their respective terminals.
Close air shutter slightly - see previous problem.
Clean jet-fire outlet with a soft bristle brush.
N415-0518 SEP 25.20
Publicité
